Ironwood-electronics Clip Use Instructions Bedienungsanleitung PDF herunterladen (Seite 2)

INSTALLING THE CLIP (CONT)

4. Apply a constant downward force after the contacts are centered between the legs.

Proper seating of the contacts is proportional to the width of the gap between the legs. The smaller the

gap, the more downward force required. The forces required range from 10 to 20 pounds.

5. Apply additional downward pressure to ensure contact between each contact and the adjacent legs of

the chip package.

Support under the board where the chip package is located may be helpful when applying this

downward force.

INSTALLING THE CLIP (CONT)

4. Apply a constant downward force after the contacts are centered between the legs.

Proper seating of the contacts is proportional to the width of the gap between the legs. The smaller the

gap, the more downward force required. The forces required range from 10 to 20 pounds.

5. Apply additional downward pressure to ensure contact between each contact and the adjacent legs of

the chip package.

Support under the board where the chip package is located may be helpful when applying this

downward force.

INSTALLING THE CLIP (CONT)

4. Apply a constant downward force after the contacts are centered between the legs.

Proper seating of the contacts is proportional to the width of the gap between the legs. The smaller the

gap, the more downward force required. The forces required range from 10 to 20 pounds.

5. Apply additional downward pressure to ensure contact between each contact and the adjacent legs of

the chip package.

Support under the board where the chip package is located may be helpful when applying this

downward force.

INSTALLING THE CLIP (CONT)

4. Apply a constant downward force after the contacts are centered between the legs.

Proper seating of the contacts is proportional to the width of the gap between the legs. The smaller the

gap, the more downward force required. The forces required range from 10 to 20 pounds.

5. Apply additional downward pressure to ensure contact between each contact and the adjacent legs of

the chip package.

Support under the board where the chip package is located may be helpful when applying this

downward force.

Ironwood Electronics, Inc.

1. Place the extractor tool between the PC board and the bottom rail of the Clip.

2. Pry up slightly on opposite sides of the Clip to loosen it from your chip package.

3. Repeat until you can lift the Clip off of the part without damage to the legs of the chip

package.

CLIP USE INSTRUCTIONS

Press down

Before

seating

Partially

seated

Fully

seated

REMOVING THE CLIP

Improper removal of the Clip from the chip package will

result in damage to the legs of the chip package.

CAUTION

Press down

Before

seating

Partially

seated

Fully

seated

REMOVING THE CLIP

Improper removal of the Clip from the chip package will

result in damage to the legs of the chip package.

CAUTION

Press down

Before

seating

Partially

seated

Fully

seated

REMOVING THE CLIP

Improper removal of the Clip from the chip package will

result in damage to the legs of the chip package.

CAUTION

Press down

Before

seating

Partially

seated

Fully

seated

REMOVING THE CLIP

Improper removal of the Clip from the chip package will

result in damage to the legs of the chip package.

CAUTION

1 2

CLIP USE INSTRUCTIONS 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Ironwood-electronics Clip Use Instructions Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Ironwood-electronics Clip Use Instructions